Isolyte S: Uses, Side Effects and Dosage

Directions for Use of EXCEL^® Container

Caution: Do not use plastic containers in series connection.

To Open

Tear overwrap down at notch and remove solution container. Check for minute leaks by squeezing solution container firmly. If leaks are found, discard solution as sterility may be impaired. If supplemental medication is desired, follow directions below before preparing for administration.

NOTE: Before use, perform the following checks:

• Inspect each container. Read the label. Ensure solution is the one ordered and is within the expiration date.
• Invert container and carefully inspect the solution in good light for cloudiness, haze, or particulate matter. Any container which is suspect should not be used.
• Use only if solution is clear and container and seals are intact.

Preparation for Administration

1. 1. Remove plastic protector from sterile set port at bottom of container.
2. 2. Attach administration set. Refer to complete directions accompanying set.

To Add Medication

Warning: Some additives may be incompatible.

To Add Medication Before Solution Administration

1. 1. Prepare medication site.
2. 2. Using syringe with 18–22 gauge needle, puncture medication port and inner diaphragm and inject.
3. 3. Squeeze and tap ports while ports are upright and mix solution and medication thoroughly.

To Add Medication During Solution Administration

1. 1. Close clamp on the set.
2. 2. Prepare medication site.
3. 3. Using syringe with 18–22 gauge needle of appropriate length (at least 5/8 inch), puncture resealable medication port and inner diaphragm and inject.
4. 4. Remove container from IV pole and/or turn to an upright position.
5. 5. Evacuate both ports by tapping and squeezing them while container is in the upright position.
6. 6. Mix solution and medication thoroughly.
7. 7. Return container to in use position and continue administration.